The amount of resizing provided by conventional reloading dies has always been dictated by the manufacturing tolerances (SAAMI specifications) of the brass cartridge case itself. Reloading die manufacturers have been forced to design the neck diameter of their dies small enough to accommodate the thinnest possible brass.

This may be as much as .008" - .010" smaller than the maximum cartridge dimensions typically shown in most reloading manuals.

Since the majority of cases that the reloader is likely to encounter in the field are thicker than the minimum specifications that the dies were designed for, case necks are often resized excessively.

It can be easily demonstrated that excessive resizing of the cartridge case quickly leads to stress distortion and concentricity problems.

The new Type S - Bushing Style Dies offer a simple solution to this age old problem.

• Uses interchangeable sizing bushings available in .001" increments.
• The adjustable decapping rod allows positioning the bushing to resize only a portion of the neck length if desired.
• Concentricity is enhanced by the ability of the resizing bushing to self-center on the case neck.
• The decapping rod is supplied with a standard size button. This is especially useful for reloaders who are using commercial brass as is.
• A decapping pin retainer is also supplied with all Type S - Bushing Dies. This enables neck sizing without the use of the size button for those who sort and/or turn case necks for uniformity.a

All dies are supplied without bushings.

71109

71111

71106

71107

71319

71317

71114

71115

71120

71531

71132

71135

71139

71142

71136

71155

71148

71275

71153

71252

71288

71223

• Uses the same interchangeable bushings (.001" increments) as those used in our bushing style neck sizing dies.
• The adjustable decapping rod allows you to adjust the bushing position, sizing only part of the neck length when desired.
• Concentricity is enhanced by the ability of the bushing to self-center on the neck of the cartridge case.
• All Type S dies are supplied with both the standard size button and a decapping pin retainer for the advantages and versatility described under our Type S - Bushing Style Neck Sizing Dies.

All dies are supplied without bushings.

77109

77111

77106

77107

77319

77317

77114

77115

77120

77531

77132

77135

77139

77142

77136

77155

77148

77275

77153

77252

77288

77223